Elite Multifunction Arm Rest T Base

• Stable & Durable – Made from solid steel for long-term use.
• Enhanced Comfort – Upgraded cushion with extra sponge padding for arms and elbows.
• Precise Adjustments – Easy button controls for accurate height and angle settings.
• Large Pillow Support – Wide pillow design for maximum comfort on all arm sizes.
• Easy Assembly – Quick to set up, disassemble, and store.
• Ready to roll - Comes with hand tools needed for assembly
• Pneumatic supported lifting - just pull the lever to lift, push down on cushion to lower. To adjust the angle of the pillow, pull the lever for adjusting the angle and move the pillow!
  
  

• Pillow Size: 50 × 37 cm (19.7" × 14.5")
• Adjustable Height: 66–93 cm (26"–36.6")
• Adjustable Angle: 0–90°

Youtube video from manufactorer with step by step instructions for similar product

Tips:

• For the central bar at the bottom have the welded square facing down to the ground when assembled.
• Use the 8/10 wrench provided to hold the bolt while tightening screws, as it provides resistance for a tight fit.
• Smaller screws are used on the pillow and pull buttons, there are holes already on the pillow. To show where the levers & stem are connected

Play by play:

1. Unbox all the pieces and tools
2. Start assembling the T frame base, sliding the U shaped leg end with the pads facing the same direction as the L shaped leg
3. Put the longer bolts in towards the direction of the feet, it is easier to do so with the feet facing up for easier viewing of the screw coming through and for full penetration
4. Attach bolt to end of bolts in the base then tighten, using the larger allen key and the larger wrench side to hold it in place for tightness
5. Line up pillow to the stem, matching the holes on the underside of the pillow with the levers and the stem. Make sure the pillow is orientated correctly for the adjustable angle (long ways of stem with long ways of pillow)
6. Use the smaller bolts and the smaller Allen Key to attach the stem and levers in place
7. Attach bottom of the stem to the T Frame Base using the long bolts and the larger Allen key
8. Tighten any loose screws, giving it a test run and wobbling it around to check for any not tight enough